This piece connects to FL-100 on one side. The other side connects to FC-100 or FV-100. The included screw is used to lock the piece in FL-100. Delivered with 2 lock clips.
Size (LxWxH): 80x60x27
Weight: 15g
General information
CoraroC is a fully 3d printed aquascape system. CoraroC will look very natural in the tank when the tank matures. The system allows you to move corals individually for fragging or trimming. You can move a single coral from one spot to another to reshape your display, or move a coral to a new location to better meet the corals need of flow and light. The scape can easily be changed, even if coralline growth is excessive.
CoraroC is available as individual parts as well as kits. If you are new to CoraroC we recommend to start with our CoraboX kits together with some of the foots or floating scape connections. CoraroC is a lightweight system to allow for optimal floating scapes. In the beginning, the pieces need to be emptied of air via the vent holes in each piece. This can be done by rolling the pieces briefly under water. The BR-100, SH-100, FC-100 and FV-100 can be filled with sand or reef cement if you like to add some more weight to the scape.
Our floating kits (CorafloaT nano and medium) are possible to use on rimless tanks with a glass thickness between 5-19mm. These kits will allow you to get one or more starting connections for branching scapes from the back or the side of your tank. The CorafloaT kits kan also be used on the bottom of the tank. You can hang the scape on the edge of the tank, but you can also glue the same pieces to the wall or bottom if you like.
Parts are easily twisted together with your hands. Just twist until it stops. You have to twist pretty hard to get a secure connection. If you like to disconnect two pieces just twist the opposite way. If the connector (CO-100) still sit put in one piece, then just push the connector with your thumb inwards. It will release the lock. Never use a plier or similar tool to loosen the connector.
Is CoraroC v2 compatible with CoraroC v1? Yes! With the connector COv1-100 you can merge between CoraroC v1 and v2.
